Run a Renard withou...
 
Notifications
Clear all

Run a Renard without a computer

43 Posts
17 Users
0 Reactions
16.1 K Views
Posts: 406
(@jboyles7)
Honorable Member
Joined: 17 years ago

agreed...


Reply
bcstuff
Posts: 449
Topic starter
(@bcstuff)
Reputable Member
Joined: 16 years ago

When searching I originally found and read this thread.

http://doityourselfchristmas.com/forums/showthread.php?10483-stand-alone-Renard-card-code


Reply
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago

is it the same as mr cristmas 6 or 12 chanell ??? i do have a mr christmas 12 chanel here but only play christmas music ,,i know there is one that also play haloweem stuff ,,just a though..
cheer


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

OK, I've got some sample code here that flashes all of the lights on and off at about a two-second pace (don't time me...) when there isn't any incoming data. It doesn't send data downstream, although code could be added to do so at the spot where new code is hooked in.

I'm not sure if I want to upload the code for general use yet, for fear that it would be confused with the regular Renard start_address firmware. Any suggestions (or volunteers) for avoiding a general mess at this point?

PS By 'here', I mean on my computer.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

Here is the "Ren Tester" http://doityourselfchristmas.com/forums/showthread.php?8146-Ren-Tester-LCD from Joeytx. I think this would be the best basis for turning a Ren Controller into standalone. Simply customize the PIC code, remove the buttons and LCD Panel (maybe not). I say this half jokingly because I was not really smart enough to modify the Assembler version.

Ideally, I would like to shrink this down to a board similar to Dirk's "Xbee Snap-in"


Reply
Page 4 / 9
Share: