Hello, I recently bought a JDM programmer from Ebay and have been trying to get it to work on my pc. When i plug in the programmer the green and red LED's turn on but when i insert my Pic16F688 the green led turns off but the red led remains on. Then I go and open Winpic800 and it says that the hard ware is seen, i can then read the chip (which already has data on it) but when i try to erase it it takes a second and says that it is erased but i can read it again and the data is still on the chip. When i try to write to the chip i get another error saying "Error -> Writing address 0x000000
Written : 0x0000 Read 0x3FFF"
I am wondering what i have done wring i believe that all the setting are correct if you could help me with this that would be excellent. I know that others have been able to get this to work and i was wondering what setting they used and how they did it
chris
Have you tried PICPgm 1.2.1.0, I use to use that and it worked fine for me, but I'm not sure it is setup for the tool you puchased. I made my own JDM programmer and I never had much luck with Win Pic 800
Thanks
Mac
i have tried it but had the same problem 🙁
ailgup wrote:i have tried it but had the same problem 🙁
How are you connecting it to the computer(are you using a serial cable?) I would try connecting it directly to the serial port. Just make sure the metal sheathing stays on if you have to remove the screws. I would also reboot the computer with the programmer plugged in. I've seen com ports act a little funny without a reboot.
ailgup wrote:Hello, I recently bought a JDM programmer from Ebay and have been trying to get it to work on my pc. When i plug in the programmer the green and red LED's turn on but when i insert my Pic16F688 the green led turns off but the red led remains on. Then I go and open Winpic800 and it says that the hard ware is seen, i can then read the chip (which already has data on it) but when i try to erase it it takes a second and says that it is erased but i can read it again and the data is still on the chip. When i try to write to the chip i get another error saying "Error -> Writing address 0x000000
Written : 0x0000 Read 0x3FFF"
I am wondering what i have done wring i believe that all the setting are correct if you could help me with this that would be excellent. I know that others have been able to get this to work and i was wondering what setting they used and how they did itchris
Are you sure you have the chip in the socket correctly?
I know my JDM programmer is sometimes confusing as to which chip has pin #1 in which position, and when it's wrong I get similar errors.
