I have tried to tinker with my new Pickit2 (clone from Sure Electronics) and these are the things that I have noticed.
1. Trying to read or load the Renard code into the pic via the MPLAB software I get the following message:
"PKWarn 0003: Unexpected device ID: Please verify that a Pic16F688 is correctly installed in the application (Expected ID=0x1180, ID Read=0x0)
2. I went into the PICKIT2 software and tested communication. I recieved the "Pickit2 Found and connected Pic Device Found.
3. I tried to burn the hex file that I got from the conversion in MPLAB and got the following error:
"PICKIT2 VPP voltage level error. Check target & Retry Operation."
My usual error message I get is usually related to the VPP voltage.
(Im looking up the voltage specs in Mouser right now)
I went into the test setup with a volt meter and I am getting the voltages that were sought after. I know voltage is being sent over to the Cradle with the three ZIF sockets (Also gotten from Sure Electronics)
The only thing that I don't think I have done correctly would probably have been doing the Programming code wizard wrong. I will try that again tonight.
The message in item 1 is more or less the usual message that I get when the software doesn't detect the right PIC in the programmer. Either the PIC isn't installed in the programmer (correctly), or there is a bad connection somewhere between the programmer and the PIC.
I did a little more research on this from Microchip.com and there is a lot of mention of a diode on D4 that would burn up before they did revisions to the code in 2006. I am still searching. I am beginning to think that I didn't use the program wizard correctly after watching Wayne's vids.
Please keep posting.
I'm curious to know if this hardware set from Sure works well or not.
It does sound like you havnt got something connected correctly. what sort of adaptor are you using for the pic chip. is it one of the zif socket boards from sure?
As for the PICKIT2 Clone from sure. the design works fine. i have been using mine for about 6 months now and must have prigrammed 50 + different revisions into different pics. all ok.
Also i might be worth installing the pickit2 software from microchip that burns the .hex files. its a bit simpler to use than mplab while your trying to resolve a hardware issue.
Peter
