Yes, that is all you will need and certainly appears to be a good deal on a PICkit 3.
Looks like Microchip has finally released the stand-alone PICKIT 3 as a product as well as the various developer kits. For those starting with the regular Renard series boards you might prefer the PICKIT 3 with 8/14 adapter to handle the 14-pin PIC16F688 chips used there.
(yet another Don)
What about the so called JDM types like EBAY 310175980234?
At $14 including shipping it's pretty cheap! Any experience with it???
Brad H wrote:What about the so called JDM types like EBAY 310175980234?At $14 including shipping it's pretty cheap! Any experience with it???
My mantra when buying tools - you get what you pay for.
This applies to crappy screwdrivers, or cheap PIC programmers. I would highly recommend skipping Starbucks for a week, and take that $ and buy a decent programmer PIC Kit 2 (or perhaps now "3"). The design is "open" and thus there are supported clones all over the place.
SureElectronics had some decent prices, or.. if you want to build up your own, look at "Blue Room Electronic's JuneBug".
It may cost a little more, but the debugging abilities alone are worth it.
That's my 0.02
I agree with LABRAT.
I have a JDM programmer and recently replaced it with a 'real' PICKIT2.
This was a very good decision and I'm glad I did it.
For a chip carrier board, I got the sure electronics board for $10 shipped off ebay. It too is a very good value. You can even buy the three ZIF sockets for $10 let alone with them integrated into a very nice board with and ICSP header.
So, for about $43 for both total, it's a good value.
I buy lots of stuff from Sure Electronics, but I see NO reason to buy their PICKIT2 clone. It really won't save you any money.
