PIC Programmer
 
Notifications
Clear all

PIC Programmer

98 Posts
43 Users
0 Reactions
64.9 K Views
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago

The thing about the JDM programmer is that JDM is not a brand. There are several different boards sold as JDM. They are all based on the original design by Jens Dyekjaer Madsen, hence the name. Some of the copies are better than others.


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

The Microchip PicKit2 is one to get. This is one area in this hobby you do not want to skimp on.


Reply
Posts: 70
(@brad-h)
Trusted Member
Joined: 19 years ago

But if one was just burning the chip with already debugged code and then it would sit in a junk drawer to perhaps never be used again??????


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Burning the PIC is not a permanent process. You can put the diagnostic code in it, test, etc. and when everything tests out diagnostically, remove the chip and re-flash it with the working code, put it back in the socket and enjoy.

A PIC can be reflashed over and over again... and WayneJ is right. Don't skimp here. You can't do better than the pickit2. And it's not very expensive at all...


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Brad H wrote:But if one was just burning the chip with already debugged code and then it would sit in a junk drawer to perhaps never be used again??????

OR... to be needed at the last minute when you blow a couple outputs on the PIC because your little one dropped his juice box in your Keptel box...

PICs are pretty cheap anyway - always good to have a couple extras of everything...


Reply
Page 10 / 20
Share: