In using the program to program the PX1 it states it ir required to use the 115 baud rate. But I buess I could try to push the 57k and see if it takes it, Guess after messing with it for hours I missed that.
the px1 can run 57600
ANGERMGT wrote: Can someone point out where on the Pickit2 screen I need to change the SS16 from 57K to 115K?
A step by step series of video on programming a pic for a renard controller http://www.doityourselfchristmas.com/wiki/index.php?title=WayneJ%27s_video_series_on_PIC_programming
There are also PDFs available that walk you through the process. http://doityourselfchristmas.com/wiki/index.php?title=Beginners_Guide_To_Programming_A_PIC
ANGERMGT wrote:In using the program to program the PX1 it states it ir required to use the 115 baud rate. But I buess I could try to push the 57k and see if it takes it, Guess after messing with it for hours I missed that.
The PX1 can be programmed at several of the standard rates including 57,600. The only downside is the number of pixels you can control, but in your case that is not an issue. http://www.doityourselfchristmas.com/wiki/index.php?title=Px1#Firmware
The easiest answer in you case would be to just use the px1 setup application listed in the wiki and set the px1 to 57,600.
Going to play with this tonight! Sometimes I get inundated and stop looking at different directions. Thanks again for the help.
Follow up. I cannot get the PX1 to work in 57600. I can get it to work with the 115200 configuring it with the Renard PX1 Config tool.
I need to change the Renard ss24 from 57600 to the 115200. I have PICkit 2 v2.62 I can read the Renard 57600 chip and save the .hex file.
Is there any instructions to edit the .hex file to the 115200 protocol speed? I also am running MPLAB IDE v8.91
