Pic 16F688 internal...
 
Notifications
Clear all

Pic 16F688 internal oscillator

6 Posts
6 Users
0 Reactions
5,156 Views
Posts: 4
Topic starter
(@bobe6rfe)
Active Member
Joined: 15 years ago
[#35050]

My external clock has failed on my renard 64, what is a good setting for the clock and baud rate for the internal oscillator?


5 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I think it will run at 19.2 w/o the oscillator with RS-232 - I don't think 57K or 115K will work without it. If you can switch to DMX (250K), you can use the 8 Mhz internal oscillator.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I believe you can get 38400 baud out of it with the crystal set at 8mhz. But that's about it. You can drop in a pic16F1825 instead and use the internal crystal and still get normal performance, and you need the 1825's firmware as well.


Reply
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

Why not replace the dead crystal osc instead of trying to change the code?


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Reducing the clock speed can cause some artifacts if you go too low. The CPU is using a large percentage of the computing power and reducing the Osc frequency can put ou into a situation where the CPU cannot keep up with the processing demands.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

The biggest issue, I think, is that of baudrate inaccuracy at 57600 baud using the internal clock.


Reply
Share: