This may save someone some time since I figured out MPLAB X and I could not find any simple instructions on the web on how to use it. I figured I would give back these instructions as I have learned so much reading what others have written. Permission given to repost or add to the WIKI just please give me credit.
Down load and install MPLAB X from microchips web site.
Down load the .asm file you need, look under firmware.
Open up MPLAB X and on the left hand side click on create new project.
Select microchip Embedded on the left and standalone on the right click next.
Select all families and the processor of you project most Renard s are pic16f688 click next.
Supported debug header NONE click next.
Hardware tool select what you have as a programmer if you do not know select Licensed debugger Click next
On the compiler select mpasm click next
Type in you project name, click on main project. Click on finish
You should be back at the open screen and on the left you should see you project.
Click on Source file, then right click on source file select and a pop up window should open.
Navigate to the .asm file you down loaded and click on the ,asm file.
Click on the source file and you should see your .asm file listed.
Right click on the .asm file and select open. You should see the ,asm code open in the window on the right.
Ok almost done. Edit the file if you need to mostly it runs with out editing it. Click on the little hammer on the tool bar and it will compile. In the bottom window you should see build successful.
If you have you programmer connected and a blank processor plugged in to the programmer click on the little down arrow with the chip under it.
Once you get the completed message take the processor out and plug it in your board and enjoy.
I am not an expert on MPLAB X but this is the process that I found worked.
Rich L
MPLAB X is a product of Microchip.
You can select the processor on the appropriate menu by simply typing the name ('PIC16F688' or whatever) in the processor field.
Also, I've always needed to tell the ide software that the processor needs to be powered from the programmer (I'm using a PICKit3) if the target CPU is board is not powered externally.
