Error when trying t...
 
Notifications
Clear all

Error when trying to program Px1

5 Posts
4 Users
0 Reactions
3,837 Views
Posts: 13
Topic starter
(@googlexx)
Eminent Member
Joined: 14 years ago
[#32685]

I've followed a lot of guides trying to figure this out. I plug my pickit 2 into my renard px1. It says pickit 2 found and connected. When I click check communication the PWR led on the px1 lights up and the Rx and Attn lights blink for about 2 seconds then all of the lights turn off and then pickit 2 programmer says unsupported part (ID=FFFF)

Any ideas whats wrong?


4 Replies
Posts: 2216
(@ctmal)
Famed Member
Joined: 19 years ago
Reply
Posts: 13
Topic starter
(@googlexx)
Eminent Member
Joined: 14 years ago

thanks for the reply. I did follow that guide and added the file. I also tried with a pickit3 and it still isn't working.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

I think that the message 'ID=FFFF' means that there is either something wrong with the PIC (or maybe it's in backwards), or something wrong in the socket-board. Or, if you're trying to program it on the PX1, a bad connection or the programmer is plugged in backwards. I think that error means that the programmer is unable to read the device ID from the PIC.


Reply
scottmcm
Posts: 621
(@scottmcm)
Prominent Member
Joined: 19 years ago

When I got that error it ended up being a bad PIC. Do you have another you can test with ?


Reply
Share: