DMX code for renard...
 
Notifications
Clear all

DMX code for renard???

33 Posts
12 Users
0 Reactions
22.8 K Views
tconley
Posts: 410
(@tconley)
Honorable Member
Joined: 19 years ago

Thank you.... This info will be very helpful


Reply
Posts: 1084
 ben
(@ben)
Noble Member
Joined: 19 years ago
P. Short wrote:
3) Terminator Resistors

The default BOM for all of the Renard boards has a 120 Ohm terminator resistor across the RS485 lines. This doesn't work well with DMX512 in most situations, so you should remove these resistors from the Renard-DMX boards, and use the prescribed DMX termination methods.

Phil, first of all let me say thank you for the beta Release. When I get a chance I will run some Renard boards and test it out.

I am curious about #3. The termination resistor for DMX is 120ohm. Are you saying the placement on the RS485 line is not good for the signal or that is flat won't work with the DMX signal? I do know the termination pins for DMX are (more than likely) not that same 2 RS485 pins.

Ben


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

You need to follow the DMX rules for terminating the line. This, I believe, means that there is one termination on the cable at the furthest possible location from the signal source (the host controller). In most cases this rule would be violated if you left the termination resistor on the Renard-DMX board (using the preferred connection method from above).

The problem with leaving the resistor on the Renard boards is that the load on the line would be too high for the RS485 drivers. The load would be effectively n+1 resistors (one per Renard plus the usual line termination resistor).


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

One added comment -

Caveat:

The front-end circuitry on the Renard boards was not designed to be DMX512 conformant, and has not been run through any of the DMX512 conformance tests. It is likely that each board will have an input impedance and sense levels that are slightly different from the DMX512 standard. It may be possible to bring the boards into conformance by careful selection of the RS485 receiver chip and the voltage divider resistor chips on the front-end, but I don't have the facilities to do this testing (and it would have to be done separately for each board, probably). On the other hand, I think that this difference would only cause problems in very large setups (many dimmers spaced over many hundreds of meters of cable in electrically noisy environments).


Reply
Posts: 1084
 ben
(@ben)
Noble Member
Joined: 19 years ago
P. Short wrote:One added comment -

Caveat:

The front-end circuitry on the Renard boards was not designed to be DMX512 conformant, and has not been run through any of the DMX512 conformance tests. It is likely that each board will have an input impedance and sense levels that are slightly different from the DMX512 standard. It may be possible to bring the boards into conformance by careful selection of the RS485 receiver chip and the voltage divider resistor chips on the front-end, but I don't have the facilities to do this testing (and it would have to be done separately for each board, probably). On the other hand, I think that this difference would only cause problems in very large setups (many dimmers spaced over many hundreds of meters of cable in electrically noisy environments).

So..... don't coil my Cat5 ontop of my subwoofer ? 😉

Thanks for the info Phil. I think Franks board will work great for termination and transfering of pins

Ben


Reply
Page 3 / 7
Share: