Is 100% really 100%...
 
Notifications
Clear all

Is 100% really 100% on?

12 Posts
2 Users
0 Reactions
6,714 Views
nathank
Posts: 204
Topic starter
(@nathank)
Reputable Member
Joined: 19 years ago
[#3060]

I'm new to the whole Renard concept, and I don't THINK that this has been raised before - but please be gentle if it has 🙂

I have built a Renard-C board and am using it for DC operation (although I think that may be irrelevant for this).

Setting the intensity to 100% and then putting an oscilliscope on the output of the 595 chip I'm finding that there is a slight dip in the output at what appears to be a fixed period of time (I'm also very new to oscilliscopes, I have just borrowed one).

What I'm finding is that when I have a channel full on I can see a very slight flicker in the light string.

This slight dip in the output of the 595, is that meant to be there? And if not, can it be removed to provide a constant "on" when the intensity is 100%?

Hope that all makes sense!

Thanks in advance.


11 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

Which version of the firmware are you using? And have you 'programmed' it for DC operation or not?

--

Phil


Reply
nathank
Posts: 204
Topic starter
(@nathank)
Reputable Member
Joined: 19 years ago

I used the firmware mentioned here: http://www.doityourselfchristmas.com/forums/showthread.php?t=1612

Are there different types of firmware for the Ren-C? I had a feeling there was only the one type?

Thanks again.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

Oops, I was thinking of regular Renard (which has different code). That firmware doesn't have any option for DC operation, so what you see is normal for the Ren-C.

--

Phil


Reply
nathank
Posts: 204
Topic starter
(@nathank)
Reputable Member
Joined: 19 years ago

Thanks for the quick response.

Are there any plans to release a firmware for DC operation on a Renard-C?


Reply
Page 1 / 3
Share: