Variable Soldering ...
 
Notifications
Clear all

Variable Soldering Iron Temperature

8 Posts
7 Users
0 Reactions
4,665 Views
kmc123
Posts: 824
Topic starter
(@kmc123)
Prominent Member
Joined: 19 years ago
[#2565]

I just saw another post that made me wonder - For those of you who have variable temperature soldering irons, what temperature (Degrees Farenheight) do you use?


7 Replies
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago

For most PCB work with 60/40 solder, I use 340°C, which would be 644°F.


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago
kmc123 wrote:I just saw another post that made me wonder - For those of you who have variable temperature soldering irons, what temperature (Degrees Farenheight) do you use?

325 degrees C here.. seems to be fine.. Melt point of solder is about 270 i think


Reply
Trepidati0n
Posts: 256
(@trepidati0n)
Reputable Member
Joined: 19 years ago

Depends upon the application...but 325 to 350 (I just get the dial somewhere in the area of need). I only go higher if h'm trying to solder something with significant thermal masses.


Reply
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago
mrpackethead wrote:Melt point of solder is about 270 i think

Actually I think it melts much lower than that. I seem to remember 60/40 being in the upper 180's and 63/37 in the lower 180's. Lead-free solders are somewhere around 215°C.

The thing is though, you'll actually burn up less components using a little higher temperature (within reason) than a lower one because you can solder quicker and apply the heat to the components for less time. I used to work for this old guy that solders boards all day long. I would only occasionally do some soldering, and he used to always yell at me for taking too long per joint. He always used to say that it should only take a few seconds per joint.

If you have never tried 63/37 solder, do it. IMHO it solders a little easier. I think that it's better because it goes from solid to liquid (and vice-versa) quicker than 60/40. With 60/40 there is a short period where it is kind of in-between states. If I didn't have a large supply of 60/40, I'd be using it.


Reply
Posts: 163
(@scharbon)
Estimable Member
Joined: 19 years ago

I set mine at about 600 degrees F. It makes for much faster and better joints. You get a nice shiny dallop of solder and your work much faster - especially around the triacs. I was working at the 425 degree range when I first started because I was afraid I would burn my components - then I realized I had bad (cold) joints - so I cranked it up and have had good results since. Hope this helps.

Steve


Reply
Virtus
Posts: 1182
(@virtus)
Noble Member
Joined: 19 years ago
omzig wrote: I used to work for this old guy that solders boards all day long. I would only occasionally do some soldering, and he used to always yell at me for taking too long per joint. He always used to say that it should only take a few seconds per joint.

Good advice almost always comes from these types of sources.


Reply
Aurbo99
Posts: 2804
Moderator
(@aurbo99)
Member
Joined: 19 years ago

I'm using a Weller WES51,

I've never taken it off "55" (Fx10) 550F.

Never had an issue yet, but I've also been soldering for 30+years now.

I guess I'm due.. :rolleyes:


Reply
Share: