Calculating total needed powersupply....
Ok.. so.. is my math correct?
16 channels.. for (staying safe) 100 nodes each.
total 1600 pixelnodes.
each pixel 0.72 W.
being safe on powersupply, so running them around 80% of max capacity.
so :
1600 * 0.72 = 1152 total Wattage at 100 % White.
(1152/8)*10 = 1440 Watt needed on powersupplies.
THATS ALOT.... lol...
Dont u agree?
Should i really get that amount of Wattage?
Sounds like overkill really.. 🙁
Regards.
Albert Markerink
If 1152 is the total wattage at 100 % at 80% you would need 922 watts (~80% of 1152) That is a total of 3 power supplies and seems about right. I am only using 1 supply for 1180 pixels and I do have some color issues with white so I am thinking about bumping it to 2 supplies this year.
John
If you run the pixels at 80%, you only need 1152 * 0.8 = 921.6.
If you are assuming 100% on the pixels and you only want to use 80% of the power supply power, then your calculations are correct.
In Christmas light speak, you don't have 16 channels. You have 16 outputs on your controller. Note also that each output has a 5 Amp fuse so you need to limit your power to 60 Watts max on each output. If your pixels each draw 0.72 Watts, a string of 100 will blow the fuse at 100% white.
Bottom line is you need a lot of power supplies to run a lot of lights at 12V.
Remember on the E682's running Ver 5 of the firmware you can set your outputs at 50%, you don't see much difference in brightness but you can lower the pixel current by around 30-40%.
I lowered my current requirements to a point where I almost was able to drop one power supply in my display.
Gary
JP90 wrote:Remember on the E682's running Ver 5 of the firmware you can set your outputs at 50%, you don't see much difference in brightness but you can lower the pixel current by around 30-40%.
I lowered my current requirements to a point where I almost was able to drop one power supply in my display.Gary
I have to figure out the controller. Haven't bought it yet. But yeah. Eventually I'll buy a 3Rd 400w powersupply. Only have 2 atm.
But taking my deco piece by piece.
How do u mean exactly Gary?
Set outputs?
In webtool?
Or just the brightness through vixen?
