Network Setup
 
Notifications
Clear all

Network Setup

11 Posts
6 Users
0 Reactions
4,975 Views
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

This video may help. https://youtu.be/g0fOZs6UgXw


Reply
Posts: 79
Topic starter
(@slim00209)
Estimable Member
Joined: 13 years ago
keithsw1111 wrote:This video may help. https://youtu.be/g0fOZs6UgXw

Thanks Keith. I have a few ideas now but I will most definitely check out that video. Just the title tells me it will teach me something. I'm all for expanding my knowledge in this topic. Also, thank you to everyone else who has responded.

Sent from my iPhone using Tapatalk


Reply
Posts: 116
(@studiopro)
Estimable Member
Joined: 12 years ago
slim00209 wrote:Thank you. Any recommendations on a wireless bridge or access point that would allow me to connect to my router without actually running a physical wire? And then run Ethernet to the controllers?

Sent from my iPhone using Tapatalk

I don't have enough experience with them to recommend one. I'm a big fan of running wire as often as you can and then using wireless when you have to.


Reply
Posts: 79
Topic starter
(@slim00209)
Estimable Member
Joined: 13 years ago
keithsw1111 wrote:This video may help. https://youtu.be/g0fOZs6UgXw

Keith,

Your video helped me out a great deal. I was already leaning towards using FPP as a bridge. In regards to that, I have one question. Once the two networks are set up, does the network switch get an IP assigned on the second network? I wasn't able to tell from the models of the Power Point.

Thank you,
Ryan


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

No. The switch doesn't know about the other network. Only the computer you set up the route on can find the other network (oh and the Pi)


Reply
Page 2 / 3
Share: