One Idea that I am working on is a 4 channel to 256 led strobe array, 8 functions ect, has anyone done this yet?
Rob
I have been using 10mm high- brightness LED's off of my old 595's as strobes. 1ch = 1strobe. Works quite well.
Frank, I have been thinking of doing this with my old 595's and Grinches also. I just didn't know if LEDs pulled too many amps for the boards or if there was enough voltage to run all of the LEDs. How does your system work? Do you run it off of 5V or do you have to provide a higher voltage power to the 595 (which means this wouldn't work with the Grinches - I think)
Steve
Basically the Idea is to program a micro-controller and use 4 of the I/O pins 3 as a sequence select and one to trigger the firmware in the controller. 4 outputs would be bussed to 16 4/16 decoder de-multiplexers as a hex number. the next 4 outputs would go to 1 4/16 decoder for chip select of the bussed decoders. and the last I/O would be the second chip select or the fire line. the strobes them selves will charge a capacitor thru a resistor to provide the current for the LED when the trigger transistor gets its fire command from the sub controller.
See Clear as Mud
Rob
fkostyun wrote:I have been using 10mm high- brightness LED's off of my old 595's as strobes. 1ch = 1strobe. Works quite well.
Frank, you wouldn't want to share a little detail on what you are doing here would you? I've been thinking about some strobes but also have spare 595 channels that could be used.
I've built a prototype high power led fixture, using 3W leds from prolight.. With the driver board i've just built, you coudl easily make it strobe.. It will drive up to 8 x 3W per channel, so 24W of LED is bright.
I think the march (or april newsletter) will have some info!
This may or may not be useful, but I've just received a whole stack of circuit boards for a 'point source' design.
It's designed around a 4 pin, 10mm common-cathode RGB LED, but you could use nearly anything you wanted.
Board is 1.6" x .6" and uses all surface mount parts. Contains a 16F688 processor and an RS-485 receiver. Input is 7-12v DC and the board regulates down to +5v. There's also a programming header for firmware hacking.
http://www.response-box.com/rgblights/2007comingsoon.shtml
http://www.response-box.com/catalog/product_info.php?products_id=40
You *could* write some simple PIC code for random flashing / twinkling. Then use one channel of your Vixen dimmers to turn the entire mess on and off. No DMX required!
Warning, thread drift.... JEC did you get the firmware on the servo controller nailed down? Last I read it was a work in progress... link to latest would be appreciated.
Tech Christmas wrote:Warning, thread drift.... JEC did you get the firmware on the servo controller nailed down? Last I read it was a work in progress... link to latest would be appreciated.
Working on it. Six channels of LED is easy, as is controlling the servos. Merging the two has proven tricky, since both systems depend on some fairly precise (+/- 4 uS) timing and have to be interleaved 'just so.'
