Countdown clock
 
Notifications
Clear all

Countdown clock

21 Posts
10 Users
0 Reactions
10.8 K Views
Posts: 1041
Topic starter
(@n1ist)
Noble Member
Joined: 19 years ago
[#14275]

Every year, we get questions and requests for a countdown clock, so I came up with this design. It has a real-time clock with a built in temperature sensor, so it could also be used for one of those alternating clock/temp displays like you find outside banks and the like. It will drive displays up to 15V or up to 100mA per segment (keeping power dissipation in mind - not both of those at the same time) so it should be good for either ready-made 6 inch ones or homebrew ones with strings of LEDs. There's an additional output per digit that can be used for colons or for backlit signs. The board also has a DMX receiver so the operating mode can be changed remotely.

I keep critiquing other people's boards, so I guess it is only fair to post my design and open it up for comments...
/mike


20 Replies
dmcole
Posts: 2196
(@dmcole)
Noble Member
Joined: 19 years ago

Mike:

Very nice design.

This would make a good surface-mount first-project kit, wouldn't it?

Is the board small enough to be done in a Seeedstudio batch (5cmx5cm)?

I assume you have firmware all spun up, right 😉 ... ?

\dmc


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

Mike, I hadn't realised how uncannily similar your design is to my 'runner's" jumpo stop watch. Main differences being I use a LM2574 for the PS and Pin headers for the Displays.
Did you get some boards mad up yet? I am about to send my off to the Fab shop.


Reply
Posts: 28
 KFXI
(@kfxi)
Eminent Member
Joined: 17 years ago

will you have boards made and if so will they be available?

Ken


Reply
griffixdc
Posts: 2512
(@griffixdc)
Famed Member
Joined: 16 years ago

it would be nice to see what they can do visually 🙂 but as a board by itself looks nice!


Reply
Page 1 / 5
Share: