Xlights Output Setu...
 
Notifications
Clear all

Xlights Output Setup Question

8 Posts
5 Users
0 Reactions
2,507 Views
Ronnie
Posts: 206
Topic starter
(@ronnie)
Reputable Member
Joined: 11 years ago
[#43774]

In the setup page if I disable "multicast" does that mean it's in unicast? If I set up fpp and my e682 as unicast, do I need to change my sequences to having "multicast" disabled in order to run the sequence in unicast? Hope that makes sense.


7 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Where are you seeing the term 'multitask'?


Reply
Ronnie
Posts: 206
Topic starter
(@ronnie)
Reputable Member
Joined: 11 years ago
rstehle wrote:Where are you seeing the term 'multitask'?

Sorry, I meant "muticast"!! I was doing too much multitasking while typing! :whtf:


Reply
Posts: 909
(@kenoman742)
Prominent Member
Joined: 14 years ago

I don't know what you mean by disabling multicast. In Xlights you have a choice (radio buttons) to select either multicast or unicast. If unicast is selected you need to enter the ip address of the controller so Xlights knows where to send the data. Unicast would have to be set up all the way through the system from Xlights to and including the controller.


Reply
Ronnie
Posts: 206
Topic starter
(@ronnie)
Reputable Member
Joined: 11 years ago
kenoman742 wrote:I don't know what you mean by disabling multicast. In Xlights you have a choice (radio buttons) to select either multicast or unicast. If unicast is selected you need to enter the ip address of the controller so Xlights knows where to send the data. Unicast would have to be set up all the way through the system from Xlights to and including the controller.

I found how to do it under "lighting networks" ("change" button). I was double clicking the row and it would change from "yes" to "no" under the enabled tab. That's what had me asking the original question. Thanks for the response.


Reply
Page 1 / 2
Share: