Using LOR as DMX in...
 
Notifications
Clear all

Using LOR as DMX in xLights

6 Posts
4 Users
0 Reactions
3,266 Views
Posts: 16
Topic starter
(@christo25)
Eminent Member
Joined: 8 years ago
[#53428]

My previous set up was 8 LOR boxes that I'm trying to convert into DMX for using in xLights.

I followed the instructions by John Storms about wiring 4-1 output on my e682 and then cabling it to the LOR unit. When I cable it, the board's LED light goes solid on the LOR like it understands it's connected to something.

OK....

But when I go into xLights and try to set up the model like Leechburg Lights did for their LOR unit -- I cannot get any output.

It's LOR Unit ID 06 -- so I have DMX channels starting at 97 (16 * 6 + 1) and still nothing coming out of the output.

MODEL INFORMATION
Start Channel = IP ADDRESS OF e682:12:97

Controller Configuration
Port -- I've tried 0 and 1
Protocol - DMX

String Properties = Single Color

When I look at the SanDevices output I see a bunch of Sequence Errors across the board... but 7x more or so in Universe 12 where I'm trying to do this from.

I've watched John's video multiple times.... the Leechburg videos --- there's a TON of good information out there and I've stayed up the past week until 1AM or so every night trying to get this stuff to work.

Help?


5 Replies
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

The LOR chart says the ID 06 is DMX 81

Sent from my iPhone using Tapatalk


Reply
Posts: 16
Topic starter
(@christo25)
Eminent Member
Joined: 8 years ago
K-State Fan wrote:The LOR chart says the ID 06 is DMX 81

Sent from my iPhone using Tapatalk

Dang... Math owns me again! Thanks for the heads up. I'll try this again later today.

ID 01 = 01-16
ID 02 = 17-32
ID 03 = 33-48
ID 04 = 49-64
ID 05 = 65-80
ID 06 = 81-96
ID 07 = 97-112
ID 08 = 113-128
ID 09 = 129-144


Reply
Posts: 16
Topic starter
(@christo25)
Eminent Member
Joined: 8 years ago

OK it's still not working...
Here's my controller configuration:

Name: SanDevice e682. |. Protocol: E131 (Unmanaged). |. Address: 169.254.x.x (using eth). |. Universe/ID: 1-12. |. Channels 6120 [1-6120]

I'm using the SanDevice to connect to the LOR CBT16PC.

I have created a custom model with 1 string and 16 nodes to represent the controller as per a video I saw on YouTube to test this out.
What should the Model's Controller Connection be?
Port?
Protocol - DMX
dmx channel?

I've set the start channel to the Universe 12 start channel 33 (because I'm using LOR ID3 and have lights plugged into output 1)


Reply
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

Not sure how old your controllers are but they need to be above a certain firmware to work in DMX. I don’t recall what they need to be above since I haven’t incorporated any LOR into my show for a few years now.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 2
Share: