Lets say I have a string of 20 pixels on a roof peak (10 up, 10 down). I want to set the top 4 pixels green, then 5 pixels down each side red, and the 3 remainder white. Is the best way to do this using submodels of the string? Or is there a better method? I'm sure this has been asked before but searching needs the right keywords, and I ran out of words earlier today.
What if you drill down to the node level and assign each node a color?
Assuming xLights. You could just have 3 layers. The bottom layer would be the ON effect, Red. Then you do the other 2 layers w/ the ON effect, green and white. Then in the "Layer Settings" window, adjust the buffer size. Since you want green on top, grab the bottom of the buffer select and bring it up to where only the top 2 nodes are lit. Then, white, bring the top of the buffer select down. Quick and dirty, but easy.
The image shows the masking off of the blue on the top.

