I would, but hey, it works for you. Just start the second controller with universe 7 channel 289 and you should be good.
I will. Thanks for your support!
First, you realize that the Pi could be stand-alone and not connected to a computer.
Second, in your first e682, since you are running 4.033, channel 4-1 through 4-4 should start at Universe 6 channel 58. You have over-lapping channels.
The second e682 looks correct. Make sure that xLights is set up to go to the correct controller before making the fseq and that the FPP is set up the same as your xLights and you should be good to go.
Keith,
I plan on using either the laptop or the Pi.
I see the problem with the first one. It's the second one that I really have a problem with. I will work on it tonight and see where I end up.
BTW, How does my model (12 strand megetree) in Xlights know to use the 2nd San Device e131 controller? I want the first 12 strands to be controlled by the first E131 device and the other 12 strands with the other controller. I did set up the controllers in the setup page with different IP addresses but when I review the model in the layout page it just shows my strings with the amount of channels. How are they assigned to the controllers.
