San device and nutc...
 
Notifications
Clear all

San device and nutcracker help needed

4 Posts
2 Users
0 Reactions
1,956 Views
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago
[#37780]
image

Hi guys can any one help me sort this out ???
I'm trying to set up a san device 682 and nutcracker, with a set of 50 pixel strings on each output ( 16 strings x 50 pixels ) to make a mega tree this year. I got the San device working to some degree but can't seem to get it all in sync.
I'm sure I set up the models correctly in nutcracker.
Thanks for any advice.


3 Replies
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

I would setup 50 pixels strings instead of 200 change group to 1 do that for outputs 1-1 to 1-4 2-1 to 2-4 3-1to 3-4 and 4-1 to 4-4. When you are adjusting channels on the sandevices screen take the ending channel add 1 and start with that universe and channel on the next output.
In xlights change your channels so they end at 510 instead of 512. Setup your megatree model in xlights using the channels you used on your e682 and you should be good.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Also, on your e682 page your start and end channels don't match up sequentially.


Reply
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago

Thanks for the help guys !
I done those corrections and ran a test with the four strings I have !!!! All working cool !
Need to get onto my friends in China now buy more lights and start the build !!!
I'm thinking of introducing a raspberry PI next to make it stand alone, so I only need to plug power in when Santa comes !


Reply
Share: