Raspberry Pi XLight...
 
Notifications
Clear all

Raspberry Pi XLights Set Up

34 Posts
14 Users
0 Reactions
39.9 K Views
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago
Heldwhat Christmas wrote:The way I did it on my E6804...
There are 4 outputs - I have one of the outputs driving my 200 pixels.
I have another output wired direct to my first Renard controllerer (use the Renard RS485 connection info)

I wasn't sure if the 682 firmware supports Renard yet - last time I looked it still said future. In the 682 GUI where you configure what pixels you are controlling check if Renard is an option.

It is, I ran my Ren48LSD's off my E682 this season.

Tory


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Livermore-Dad wrote:It is, I ran my Ren48LSD's off my E682 this season.

Tory

To clarify - you ran them in Renard/Serial mode (e.g. 57K or 115K) or Renard/DMX mode - for sure the DMX version has always worked - I ran my LSD's for two years that way as well.


Reply
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago
budude wrote:To clarify - you ran them in Renard/Serial mode (e.g. 57K or 115K) or Renard/DMX mode - for sure the DMX version has always worked - I ran my LSD's for two years that way as well.

Renard 57K.

Tory


Reply
Posts: 1
(@aviator)
New Member
Joined: 6 years ago

Is the raspberry picap able to run on a xschedule show with other controllers or does it specifically have to be uploaded to falcon player to run the show? I'm able to run tests through xlights but my other controllers are packed away so I can't test a sequence at the moment.


Reply
Page 7 / 7
Share: