Raspberry Pi XLight...
 
Notifications
Clear all

Raspberry Pi XLights Set Up

34 Posts
14 Users
0 Reactions
39.9 K Views
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

That may be a possibility. You should ask that where the Guru's are:

http://falconchristmas.com/forum/index.php?board=8.0

Dave


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Two questions; What's a good sized flash drive to use for 5-6 songs and sequences and I realize you build a sequence in say HLS, covert it in xLights and then run it on the Pi, but it will send out Renard via e1.31 for my Renard controllers and e1.31 to all my pixel controllers. I'm a little fuzzy on the connection from Network e1.31 Renard to the first controller. e1.31 Bridge???


Reply
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

I have a 2Gb usb drive, but I also have an 8Gb. These are very cheap but I would get a well known brand. The system I have is the Pi outputs E131 to an ethernet switch then to a Sandevices E6804. The 6804 outputs renard,DMX and pixel data per the universe assigned. It works great and is consistant. I have it on 24/7 for over a month now. My system consists of a Pi, Powered USB hub (which powers the Pi), Vast FMT212R FM transmitter and an Edimax USB WiFi wireless. It outputs the E131 out the ethernet port of the Pi to the E131 controller(s) via the switch. I control the Pi by the wireless connection. Hope that helps a little Scott.

Dave


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Yes, Dave that helps, but are you all pixels with E68X controllers or do you have some Renard boards in there? That's where I need to make the connection. Right now my Renards are Universe 11 to a serial, the pixels are on other Unicast Universes, which are a no brainer.
Just need to know the hardware to connect Renard boards to a e1.31 network.


Reply
Electrified3
Posts: 716
Topic starter
(@electrified3)
Prominent Member
Joined: 13 years ago

Scoot, read up on sending the data to the Renards out an output of the E68x controllers, saves a pile of work, no need to buy adaptors, bridges, dongles, it is already there! Depending on your ability can make a custom Cat5 cable from the output or buy a pre-fab Cat5, cut and strip 1 end and connect the correct wires to the output of the E68x, configure it and away you go.

I think someone already said about the cost of USB flash drives. They are so cheap no. If concerned convert a few shows you have to the FPP format and see how big they are? I am sure they will not be that big, but it is a flash drive, they are cheap and easy to change out if you need to go bigger.


Reply
Page 5 / 7
Share: