Nutcracker how do I...
 
Notifications
Clear all

Nutcracker how do I skip reserved DMX addresses

4 Posts
2 Users
0 Reactions
1,554 Views
Posts: 77
Topic starter
(@croberts)
Trusted Member
Joined: 11 years ago
[#40422]

I searched for a while to find the answer, I thought it would be common.

I’m testing a pixel tree in Xlights4. It is 10 x 50 pixel strings using an AlphaPix 16 V2 controller. I have 250 pixels in output 1 and 250 in output 2. I manually set the start numbers for each string after manually testing each pixel in the test mode of Xlights4.

What I noticed is string 4 is still using channels 510 – 511 and string 9 uses channels 1535 – 1536 which is throwing off the colors of 1/3 of each string. I know they are reserved DMX channels.

What I can’t figure out is how to have xlights4 skip those channels in the string. You can manually set the start number of the string but I have not yet found how to manually skip the reserved channels.

Today I added a 300 pixel strip and noticed its doing the same thing.

Tree map
1 – 150
151-300
301-450
451-602 – 2 extra 510-511
603-752
1025-1174
1175-1324
1325-1474
1475-1626 – 2 extra 1335-1336
1627-1776


3 Replies
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago

In your xLights 4 Setup tab, go to the E131 entry for that Universe, click "Change", and then change the "Last Channel" from 512 to 510.


Reply
Posts: 77
Topic starter
(@croberts)
Trusted Member
Joined: 11 years ago

WOW, the answer in 10 minutes. That was fast. Thank you, I will try it now.


Reply
Posts: 77
Topic starter
(@croberts)
Trusted Member
Joined: 11 years ago

It worked. Thank you so much.


Reply
Share: