No data being sent
 
Notifications
Clear all

No data being sent

10 Posts
4 Users
0 Reactions
2,901 Views
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago
[#32761]

I created a simple 1 universe sequence to be able to test some pixel extenders. I am using a 6 port E1.31 bridge and have it set up correctly. I have the lights on checked but when I play the sequence with the pixels attached no lights come on. When I call up the web page for the bridge all the packets sent/received remain at zero. I changed my cat5 cables and tried xlights in test mode but still no lights.


9 Replies
wbottomley
Posts: 550
(@wbottomley)
Prominent Member
Joined: 18 years ago

Have you switched the jumpers from DMX to Renard?


Reply
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago

Yes. I also ran a test program I downloaded and my network checked out ok. The pixels work using the program just not with xlights.


Reply
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago

If I remember correctly it was scanview that I used to check out my network settings.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Sounds dumb, but did you check the output to lights box at the top of the window in XLights? Also, be sure any test programs have their test mode off.


Reply
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago

Got all that. I'm sure I'm missing something simple.


Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

So u can output in the test, preview and nutcracker tabs but not in the scheduler?


Reply
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago

I can't get xlights to do anything. Scanview works. I'm not at home for a while so I'll have to play with it later.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

One more thing, what do you have the controller set at? Multicast-Unicast? Did you set the XLights configuration the same? I have been hosed by that one before as well.


Reply
Posts: 128
Topic starter
(@yukonmike)
Estimable Member
Joined: 14 years ago

I got to the house and checked everything again. I had set the 1.31 bridge to unicast and made sure unicast with the same ip assigned was in my xlights setup. All it is is one 50 pixel string. Just for the heck of it I changed the settings over to muticast on the bridge and in my xlights setting. I rebooted the bridge and now its working. I have a pixel extender attached to the bridge and made sure I moved the jumpers from DMX to Renard. I thought if I went unicast and the the correct IP address assigned it should have worked. I went to unicast so that I wouldn't be limited to 6 universes on the 1.31 bridge.


Reply
Share: