Yesterday I finally got all my new arches put up and connected. I'm using 3 E6804 controllers, each driving 4 100-pixel strips of Rays 5m 2811 strips. When I tested some of the Nutcracker effects that I defined, the output to the lights couldn't seem to keep up. I exported one of the effects and pasted it into an existing LOR sequence and tried that, I saw similar results.
I was running the test from my laptop connected via wireless to my home network. The wireless box connects to a router in my house, from there I have a cable going outside to a small hub, and from there to the 3 E6804s. I don't have a computer at home with a wired connection to try, but is the wireless connection likely to be my problem?
Eliminate the wireless and retest.
I have to agree with wbottomley. Also are you using Unicast or Multicast? I would suggest Unicast to minimize network traffic.
James
I am running multicast. When I first got the controllers and set things up to test in the house, I couldn't get unicast to work, so I gave up after multicast worked fine. Any help somebody could give on how to configure for unicast would be greatly appreciated! My goal for this year is to incorporate the arches into my existing LOR sequences. Next year I hope to use just xlights/nutcracker...
What firmware are you running on the E6804? I do not have oe so I am not sure but can the E6804 be configured for Unicast? I think it can but not sure, as the E680 can not unless it is updated with a new wiznet module and firmware.
Basically, Unicast is direct transmission to a particular unit based on ip address. Multicast send the info out to every controller. So Unicast will use less of the network bandwidth. You would have to set the controller to listen for Unicast in its config page and then set xLigths to send out unicast and specify the ip address of the controller.
Things are better already. I read through a few old posts, and it appears that when using unicast, you can't have a universe that spans multiple controllers. Of course, that is how I had things setup. I reconfigured the E6804s with unicast instead of multicast, each output on its own universe, and 4 universes per controller. Then I altered my xlights setup to use 12 universes of 300 channels each instead of the 8 universes of 510 channels that I had. I think things look much better now. It's hard to tell with everything in daylight, I will know for sure tonight. Changing the configuration in xlights was effortless, the real nightmare is still ahead, changing my LOR configuration. This reinforces the need to switch everything over to xlights/Nutcracker...
