Megatree string num...
 
Notifications
Clear all

Megatree string numbers.

9 Posts
5 Users
0 Reactions
3,127 Views
Posts: 43
Topic starter
(@dicklinn)
Eminent Member
Joined: 14 years ago
[#34248]

Using Nutcracker Xlights on a 360 degree megatree with 24 strands where is string #1? Does it run clockwise or CCW?


8 Replies
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

if the street is 6 o'clock, first strand is at 12 o'clock as viewed from the top. default direction is ccw, but you can change that by changing the starting corner.


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

However, note that if your tree is physically not setup that way, you can always change the individual start channels for each string. My tree has the first string at the 9:00 position as that's where HLS defaults. I went into the model and set the start channels for each string. For my 22 string tree, the 6th strand is in 9:00 position so that gets the lowest start channel and then I went around from there.


Reply
klyneshouse
Posts: 230
(@klyneshouse)
Reputable Member
Joined: 16 years ago
smeighan wrote: .....default direction is ccw, ......

Just so I am current.
So any 360 mega tree model should be wired counter clock wise around the base?

I just realized in current xlights 4.2.xx there is not selection box for cw/ccw as in the older versions.


Reply
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago
klyneshouse wrote:Just so I am current.
So any 360 mega tree model should be wired counter clock wise around the base?

I just realized in current xlights 4.2.xx there is not selection box for cw/ccw as in the older versions.

In 4.2.23 there is a selection for start point.


Reply
Page 1 / 2
Share: