Help a newbie to sc...
 
Notifications
Clear all

Help a newbie to scroll some text

4 Posts
3 Users
0 Reactions
2,230 Views
Posts: 2
Topic starter
(@gabi68)
New Member
Joined: 18 years ago
[#56549]

Hi, newbie here (with xlights, long time time wled user). I have a matrix 16x16 configured in xlights (run by a ESP32 under wled) and I try to put a text effect on. The result is wrong. The text is setup to go from left to right. In reality the effect is going from left to right and from right to left in the same time. It looks like the signal is doubled and inverted. How can I solve this?


3 Replies
Posts: 2
Topic starter
(@gabi68)
New Member
Joined: 18 years ago
MikeKrebs wrote:how many models do you have configured for the matrix? How many layers are you using in the sequence?

One model. only this matrix. Also one layer since I trying to scroll some text. All checks are green, not even a warning....


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

I would call into the xLights Zoom Room. They will want you to share screens, but those guys are great and should be able to pinpoint your problem


Reply
Posts: 80
(@jerryg)
Estimable Member
Joined: 11 years ago
gabi68 wrote:One model. only this matrix. Also one layer since I trying to scroll some text. All checks are green, not even a warning....

I had a similar issue before, mine ended up being a case where my xlights model did not match my controller setup. ex. mine was a 24x48 for a 24 row matrix I used 12 strings of 96 and had the controller do a zig-zag every 48 nodes. What controller are you using? You may be able to share a screen shot of the model setup and controller setup. Also make sure you have the start corner defined in both the same, mine started at bottom left which may be the default but can't remember.


Reply
Share: