Getting "not respon...
 
Notifications
Clear all

Getting "not responding" error message when saving XL/NC files

5 Posts
3 Users
0 Reactions
2,124 Views
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago
[#32304]

Posted over in XL/NC forum also..... I think this might be a PC problem, but I figured I would post anyway and see what ya'll think or might advise. I am setting up effects for a megatree that is 20 strings x 90 RGBs per string. I manually setup XL/NC such that each string is a "separate" universe==string 1 is universe string 2 is universe 2, etc. When I save the xseq file, I get a fairly long file save process (on the order of a minutes) where the PC tells me it is "not responding". Am I perhaps causing myself problems setting up the tree with 20 universes? If so, I can change it such that XL/NC does its normal job of auto-assigning the channels' IDs for me. I am guessing that my PC might be the main problem here as it is about 4 years old and is equipped with 4 GB of RAM onboard. The PC is running an intel i3 processor running at 2.53 GHz. BTW I could install another 4 GB of RAM if anyone thinks that would make a difference and would be worth spending some $$ on an older PC (a laptop). Thanks in advance!!


4 Replies
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

my setup is 48 universes.
it takes a few minutes to save, maybe up to 4-5. this is when it fully renders everything. My megatree takes longer to render each row than my singlestrand eaves.

xlights only uses a single processor and it uses only a few hundred megabytes

how many models do you have?
my megatree is 20x120

did it finish writing the xseq? Can you watch it while it is running? Do a Ctl-Alt-Del and run the Task Manager. look at the cpu% and memory column. what else is running on your machine?


Reply
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

Windows will issue the "Not Responding" message if the windows pump is not called periodically.

Sean ....

Just make sure the working thread you are using to do the work calls Windows to process messages every 1sec or so.

If your working thread does not do that --- Windows pops the message.

You can ignore the message and wait ... see if it finishes.

The purpose of the message is ..... if a working thread keeps in a loop it can't break from ... Windows tells the user in case the loop is never broken.

Joe


Reply
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago

Thanks Joe and Sean. I guess I just need to be PATIENT!!


Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

Remember Joe we are not Window specific. Our code is available native to OSx, Linux and Windows. We already output a status line on every cell of the matrix for each model. These are usually more than once a second.

I have never seen "Nor Responding" when i save my sequences, others have not reported it. xlights is a single thread 32 bit program. matts code never seems to use more than half of a single cpu. we talked about making it multi threaded someday, but performance is not near the top of our todo list since it can drive 64K channels on a single cpu.

thanks
sean


Reply
Share: