How are your computer and controller connected together when they are in the same room? I assume direct ethernet cable? What IP address does your computer have when it's directly connected to the controller? If it's DHCP it may not have a valid address. Is there wireless adapter on the computer connecting it to the home network? turn that off. You shouldn't have two different interfaces on the same computer on the same subnet but headed in different directions.
It looks like the controller is set to 192.168.0.5\24 Make sure the hardwired connection from the pc has an ip address on that subnet (something like: 192.168.0.4\24) and turn any other wired or wireless interfaces off. Now see if you can reliably connect to the controller.
It doesn't make a lot of sense the your test output aren't working especially since you have 3-1 turned off in you config. You may need to explain that a little more. Did you configure output group 3 and test this?
Alan
Success !!!! I got the four strings blinking to a few xlight sequences with controller plugged into router. Just can't seem to do it with them plugged into computer ?? Not a major problem as ultimately I want to use a raspberry PI and falcon to run the show... Time to buy some more lights !!!! Thanks for the advice
When your controller is direct connected to your computer are you using a crossover cable? If not they are trying to talk on the same pairs.
With modern hardware you normally don't need crossover cables. I've direct connected my laptop to all the different light controller boards no problem. Usually I have my board programmed to something like 10.10.10.12. So when I connect my laptop I have to make sure its IP address is on the same 10.10.10.x subnet. So you go into the properties for the hard wired LAN interface and modify the IPv4 settings and instead of obtain an IP address automatically you need to type one in like for me I can just type 10.10.10.1. Now that they are on the same subnet they can talk to each other. By the way I only use Unicast. I never got multicast working for my yard so I like sticking with hard coded addresses.
Also I was wondering if you realized that when you told the board it had 4 outputs that you needed to daisy chain your pixels. That's why it ended on Universe 2 channel 90. Four strings at 50 nodes is 600 channels so it was filling up the first 510 in Universe 1 and then 90 spilled over to universe 2. If you're actually connecting one string per output you need to change that setup to activate all four outputs and set it to 1 for each output. I wasn't sure how you were connecting so wanted to make sure.
Oh and I wanted to add that if you are daisy chaining are you using power injection? Thats too many pixels for one run with power injection. If you already mentioned this I apologize...I don't fully read every post.
