E682 nutcracker hel...
 
Notifications
Clear all

E682 nutcracker help

14 Posts
8 Users
0 Reactions
4,037 Views
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago

Thanks guys for the support. I ain't got a lot of time to go at it loads with kids, a job, dogs and of course the missis ! But I got an e682 kit last week and put it together last weekend and tonight I got the test programs blinking right. I just not sure about configuring it with xlights yet. I'll try multicast soon as I can and report back.
Thanks all


Reply
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago

Ok first question is if I sellect multicast in xlights the IP address is grayed out meaning I can't put an address in ? So is number of universes, am I supposed to add another one to it ? I've setup my model with 4 strings of 50 pixels.
Now into 682 page I am setting outputs in use to 4, pixel length to 50, start address to uni1 ch1 but end address is froze at uni2 ch90? That just don't seem right to me ?

image
image
image

Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

4 strings of 50 is 200 pixels or 600 channels. E682 uses 510 channels per universe. So 510+90=600, yes it is correct.

In xlights set up two universe of 510 and you are ready

Sent from my iPhone using Tapatalk


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago

That will give you individual control of each pixel. I assume you want that, in which case Sean is telling you true. If you were planning on having the se thing mimicked on all the strings, there is a different way to set that up.

Short and badly typed since written from my phone...


Reply
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago

Yes I want individual control of each pixel, Im really struggling to get my controller to communicate with my computer. I have forced my way into the 682 with it connected to my computer, entered the temporary IP address into the address bar then changed the IP address to one that works with my router.
now I can only get the test patterns to work on output 3-1 if I take the controller into another room away from my computer and plug it directly into the router which for obvious reasons is no good.
need to sort this out first before I can go onto setting up pixels..... hmmmmm !!!


Reply
Page 2 / 3
Share: