E682 nutcracker hel...
 
Notifications
Clear all

E682 nutcracker help

14 Posts
8 Users
0 Reactions
4,038 Views
Posts: 66
Topic starter
(@cliff-smith)
Trusted Member
Joined: 13 years ago
[#36417]

Hi all , I'm going pixels this year and am struggling with setting up my new e682 with nutcracker.
I've got my 682 connected to my router with a ethernet and I can get the web page on my computer using an IP address. Iv downloaded nutcracker and worked out some sequence now I want to output to some lights. I have got 4 strings of ws2811 for now to get me started with but I can't workout were to start setting up the two programs ??? Should I be looking at multicast or unicast, how many universes should I be looking to set up and number of channels in each universe ?
Eventually I'll buy maybe 24 strings and have 100 pixels on 12 outputs.
Thanks in advance for the help or ideas


13 Replies
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

Start simple. Select multicast, setup to start at ch 1, univ 1. In Xlights set channels per universe to 510. Go to test tab and select some rgb patters

Sent from my iPhone using Tapatalk


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago

And may I suggest (this is coming from experience being in the same boat as you last year), if you still have some issues after what Sean wrote, puts some screenshots up of your e682 and xLights setups, it makes debugging from afar 100x faster/easier.


Reply
Akentut
Posts: 235
(@akentut)
Reputable Member
Joined: 14 years ago

CLIFF, like wise here, my first setup this past christmas was a learning curve, but the ppl here sure helped me out. I just purchased my 4th unit and will probably stop there. (NOT 🙂 ).

But if you do run into problems, I've had them all and found these addicts know their stuff. Numbering the system is the most important part, and using xLights adds a bit more to the mix. Counting pixels for different displays is tricky. I had different size trees, along with a few arches, and a Star, along with a 400 pixel MegaTree, which this coming Christmas will be 800. (Yep, it will use one entire controller).

Alan


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

And you are DEFINITELY doing the right thing getting started early! This RGB stuff is not rocket science, but there are a lot of little details that ALL have to be right to be able to make your RGBs blink... May I also suggest that you consider downloading SACNview. It is a free download and I used it my first RGB year. It "looks at" the e1.31 universes and it can help you troubleshoot what is going on. It helped me a lot. But I think Sean's suggestion to use xlights as your troubleshooter is probably the best first place to start your troubleshooting.


Reply
Page 1 / 3
Share: