DDP to E1.31
 
Notifications
Clear all

DDP to E1.31

19 Posts
4 Users
0 Reactions
19.1 K Views
ChiefWarrant
Posts: 570
(@chiefwarrant)
Honorable Member
Joined: 19 years ago
Santacarl wrote:
The only reason I can think of to run both on the same controller MIGHT be if you want to run Renards and pixels on the same controller

Fun Fact: The F16v3 can run Renard straight off the board. It just uses the channels you assign to it from either DPP or E1.31. As long as your show profile and the board configuration matches, it works. This Rendard direct support is one of the things I always liked about Falcons.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
ChiefWarrant wrote:
Controller | Max Pixels | Channels | Bandwidth @ 44 FPS | Bandwidth @ 20 FPS
------------------- | ---------- | -------- | ----------------- | -----------------
Falcon F16v3 | 16,384 | 49,152 | ~17.3 Mbps | ~7.9 Mbps
SandDevice E682 | 6,400 | 19,200 | ~6.8 Mbps | ~3.1 Mbps
Combined | 22,784 | 68,352 | ~24.1 Mbps | ~11 Mbps

Takeaways:
- Well under Cat5e (100 Mbps) capacity.
- DDP efficiently handles pixel data.
- PC/FPP combo mainly manages rendering and timing; network bandwidth isn’t the bottleneck.

So, if my F16v3 has an expansion board the channel number is potentially doubled. What happens to the Bandwidth?


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
Santacarl wrote:
So, if my F16v3 has an expansion board the channel number is potentially doubled. What happens to the Bandwidth?

Oops....misspoke....the number of outputs, not channels, is potentially doubled....per the user manual...Oops! So I'm guessing bandwidth isn't impacted by an expansion board.


Reply
ChiefWarrant
Posts: 570
(@chiefwarrant)
Honorable Member
Joined: 19 years ago
Santacarl wrote:
Oops....misspoke....the number of outputs, not channels, is potentially doubled....per the user manual...Oops! So I'm guessing bandwidth isn't impacted by an expansion board.

Adding an expansion board to the Falcon doesn’t increase the total channel capacity. The max channel count stays the same — it just gets divided across more ports.


Reply
Page 4 / 4
Share: