DDP to E1.31
 
Notifications
Clear all

DDP to E1.31

19 Posts
4 Users
0 Reactions
19.1 K Views
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
[#58707]

Hey All,

I have an F16v3 that is setup to receive via DDP. Can I daisy chain from the F16v3 to a controller (Sandevices E682) that can't receive via DDP? The E682 receives E1.31.


18 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

The ethernet interfaces on the f16 are a small switch, that means it is not a daisy chain configuration. It is a network extension just like adding any other switch


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
MartinMueller2003 wrote:
The ethernet interfaces on the f16 are a small switch, that means it is not a daisy chain configuration. It is a network extension just like adding any other switch

Thanks Martin,

I was referring to "daisy chain" as in next down the line. That's a holdover from my Renard beginnings! Haha....I wasn't sure if the FPP would send/pass E1.31 data to the F16v3 since XL and the FPP know that the F16v3 is set for DDP.

But based on your reply I think I hear you saying that the "Network" has both E1.31 and DDP data transiting the net simultaneously. So, if that's the case, my E682 should receive E1.31 because its connection just happens to be located on the F16v3 board? Please check my logic.... Networks baffle me and I often make a mess of anything network related. Haha.


Reply
ChiefWarrant
Posts: 570
(@chiefwarrant)
Honorable Member
Joined: 19 years ago
Santacarl wrote:
But based on your reply I think I hear you saying that the "Network" has both E1.31 and DDP data transiting the net simultaneously. So, if that's the case, my E682 should receive E1.31 because its connection just happens to be located on the F16v3 board? Please check my logic.... Networks baffle me and I often make a mess of anything network related. Haha.

@Santacarl,
Your logic is correct. The E682 will have its own IP address, just like the Falcon. The Falcon’s mini switch ignores any E1.31 data not intended for it and simply passes those data frames along to the next device in your daisy chain without alteration. The E682 then recognizes the data meant for it, reads it, and processes it accordingly.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
ChiefWarrant wrote:
@Santacarl,
Your logic is correct. The E682 will have its own IP address, just like the Falcon. The Falcon’s mini switch ignores any E1.31 data not intended for it and simply passes those data frames along to the next device in your daisy chain without alteration. The E682 then recognizes the data meant for it, reads it, and processes it accordingly.

"Chief"....thanks for the verification.


Reply
Page 1 / 4
Share: