Chromacane 99 Wirin...
 
Notifications
Clear all

Chromacane 99 Wiring

1 Posts
1 Users
0 Reactions
1,670 Views
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago
[#55707]

I created my 5x Chromacane 99's in Xlights and by default they were facing left but I wanted them facing right. I was able to flip the model horizontal getting it to face the correct direction, however now that I'm ready to wire the canes up I was confirming with the wiring diagram in Xlights and it doesn't seem right.

When looking at the wiring diagram I was assuming I'd see the cane facing the opposite direction, however as you can see in the attached image the wiring diagram on the right and the model on the left are facing the same direction. It appears that I need to start pixel 1 on the bottom outside row, zig zag the first two rows wrap around and end up with 99 next to 2 but I wanted to be sure. I've seen a post in the past where someone had issues with the effects displaying properly and since my controller for these isn't setup yet I wanted to double check before wiring up all 5.

Thanks
-Russ

Screen Shot 2022 04 03 at 5.51.16 PM

Share: