Will my setup work?...
 
Notifications
Clear all

Will my setup work? 1st ever mega tree

12 Posts
7 Users
0 Reactions
4,644 Views
Posts: 16
Topic starter
(@newlifer89)
Eminent Member
Joined: 9 years ago
[#46618]

Hey all. So I am wanting to do a mega tree. I decided to do a 15ft total tree.

I am going to use two 10ft fence post as the base. I am going to cut one of the 10ft post down to 5ft.

As for the base I am going to use a post hole digger, and put either a PVC or metal pipe slightly larger then my fence post into the ground and surround it with concrete. Therefore, I can easily remove the tree at the end of the year. I was going to put the pipe a few inches under ground so my lawn mower doesnt hit it in the summer season.

I was going to run appox 36 lengths of 16' 8" LED strands. I was going to make the base diameter 10 - 12ft.

I was going to make a loop in the strand and zip tie it. Then take one large, strong zip tie and attach the lights to the fence post at the top. I might put a hose camp on as well so nothing slides down. Then in the ground, I will use tent stakes to keep the lights tight.

Will this work? Do you think I need to add guild wires?

Thank you for your time and reading this post


11 Replies
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

sounds ok to me. only thing i would worry about is how you are going to attach the strings to the top. you might want to think of something better than a hose clamp


Reply
Protege94
Posts: 556
(@protege94)
Honorable Member
Joined: 10 years ago

Yes this should work. Sounds like my setup I run the lights from the top of my pole to the ground and then use tent stakes to hold them in place.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

You will want to use guy wires at least initially. The fence posts will slip around a lot at the joint between the two and you'll end up with a lopsided tree if you don't stabilize them. Speaking from experience here. 🙂


Reply
Posts: 16
Topic starter
(@newlifer89)
Eminent Member
Joined: 9 years ago
Kensington wrote:You will want to use guy wires at least initially. The fence posts will slip around a lot at the joint between the two and you'll end up with a lopsided tree if you don't stabilize them. Speaking from experience here. 🙂

Thank you! How far out from the pipe do you run your guild wires? Also are you guiding from the top or middle? I was thinking about running 4 pieces of paracord. I can tie up very tight, unlike true wire.

MrDudeman, what do you suggest? I was going to run a zip tie through all the strands loops, and pull it tight. I dont want to use a hose camp to secure the lights because I dont want the metal on metal to cut the wire any. I was going to put the hose camp under the zip tie so the zip tie doesnt slide down.


Reply
Page 1 / 3
Share: