Hi y'all!
I'm starting to plan the star for my mega tree.
The tree is right at 20 feet, 360, 3 inch spacing... I would like a moravian star type, or a 3D type of some sort.
1. Size is important, I don't want something that is going to be too tiny up there. Or too big either... Any samples or suggestions would be helpful.
2. Does anyone make one that is sufficient, I saw that Boscoyo started to show one that might work, but haven't seen it since.
3. If I tried to make one (I have plenty of coroplast) is there a pattern that would work that I can add pixels to? And, am I just opening a can of worms and wasted Coro...
4. I've seen some on Amazon or eBay... Are any decent, that will last outside and structurally solid that I can take apart, add pixels, and put back together?
Any help, tips, or suggestions is always greatly appreciated.
Thanks,
~ Sean
Lowe's had some. Two sizes. The larger fits pixels nice, even gece fit. Joel has a thread here with pictures. Size is a very subjective thing. And by your post I'd say your on the picky side of size (me too). So lay out two strings (or rope, whatever) at the same length and angle as your tree on the ground. Then you can put different size paper stars at the top and get yourself a ballpark of the size you want.
Jrock64 in how to section. Moravian Star Check.
Skunberg wrote:Lowe's had some. Two sizes. The larger fits pixels nice, even gece fit. Joel has a thread here with pictures. Size is a very subjective thing. And by your post I'd say your on the picky side of size (me too). So lay out two strings (or rope, whatever) at the same length and angle as your tree on the ground. Then you can put different size paper stars at the top and get yourself a ballpark of the size you want.
Great idea, never thought about the paper star! That will help big time... A 20" star is a whole lot different than a 48" star 🙂
I have the 3 layer star from ChristmasLightShow.com and it looks good on the top of my 18ft tree.
Here's an idea. Put a sparkle ball at the top. Made with 50 solo cups and pixels. I've made 2 of them so far and xlights mapping on them looks really good.
I've seen the solo cup sparkle balls,... Pretty neat idea, but I might use that idea for another project.
jnealand wrote:I have the 3 layer star from ChristmasLightShow.com and it looks good on the top of my 18ft tree.
+1 on the christmaslightshow.com I have 2 of these stars on my 2 mega trees...very solid powdercoated steel...
I have the the flat star that boskoyo sells...48" tall...on top of my 20' Tree...(2" spacing on my pixels)
see it here:
dgirard wrote:I have the the flat star that boskoyo sells...48" tall...on top of my 20' Tree...(2" spacing on my pixels)see it here:
That star looks quite good! It's actually hard to tell that it's flat from the ground perspective. Thanks for sharing your tree! I'm also looking at 20ft with 3" spacing.
