I am working on my spiral tree. It is 12" tall sits inside my 16' megatree. I am using sixteen strings of lights I have 16 guy wires evenly space around the 6' diameter base. My first attempt had the strings too far apart at the top.
Am I correct in assuming that I need to get eight strings on without any overlap and that the second eight will overlap or should none of them overlap or cross?
Ok, I figured it out. In my case no overalp and the problem is I was trying to go channels 1,2,3 .... clockwise when I needed to go 16,15,14.... counterclockwise. Spiral is up!!!
They should not overlap. They will be tight at the top. Use your 16 Guys wires. I would attach the strings where each guy wire attaches at the top. Get one wrapped in a way you are happy with. It should attach at the bottom where one of the guy wires attaches to the base ring. It won't necessarily be the same guy wire as you started on and that's ok. For your 2nd one, go one guy wire to the Right at the top and start wrapping. It will be close at the top, but them gradually get farther apart as you go. You should finish at the bottom exactly one guy wire to the right of the previous one.
It's hard to explain, but use the guy wires to space it evenly. Pick 3 or 4 points on the where the first string crosses a guy wire. Wire tie it at that point. Then all the other strings should cross a guy wire on that same horizontal plane. Clear as mud right? Sorry.
Have you used the Spiral tree Calculator Spreadsheet?
Thanks, KY. That is basically what I did. I did two wraps and because I am doing a tree trunk style I was able to use the guy wire as measured anchor points and didn't have to worry about excees or short lenghts. Yes I did use the spiral calculator
Thanks for the post,I spent 3 hrs yesterday trying to get my spirals up and I had a mess.
I will start all over again after work today.I finally used my guy wires to hold the other strings out of the way and that helped alot.
I wish there was an easy way:lol:
Xenia wrote: I was trying to go channels 1,2,3 .... clockwise when I needed to go 16,15,14.... counterclockwise. Spiral is up!!!
THIS PART!!.. UGH.. it took me 3 trys and 6 hours to get mine up and no wonder.. i wrapped them the wrong way too LOL...
Deleted.
