Quick Mega Tree Qu...
 
Notifications
Clear all

Quick Mega Tree Question

6 Posts
5 Users
0 Reactions
2,737 Views
Posts: 46
Topic starter
(@zanclus)
Trusted Member
Joined: 14 years ago
[#32028]

Hi
I am building my 1st Mega tree this season. It will be 16 strands of 50 Pixels (5v). My question is this: I am using an E682 to control the pixels , taking up almost 5 universes . The E682 supplies power to the pixels. What would be my best option setting the pixels up? if I connected each strand to its own port on the E682 would I need to inject power to each strand. I am using a 350W power supply connected to both sides of the E682? Thanks for any input you all may have!!!


5 Replies
Posts: 206
(@tallahassee-dreamer)
Reputable Member
Joined: 17 years ago

I am using nearly the same set up and reached out to Jim St John at SanDevices and he advised me that you would use the power from your 350W supply to the controller and there would be no reason to inject power elsewhere. Keep in mind however that you may need 2 Power units as I have
32 strands and am utilizing 4 power supplies per Ray Wu. Give Jim a call at San Devices (317) 663-0576 and he can guide you safely along the way.

Zanclus wrote:Hi
I am building my 1st Mega tree this season. It will be 16 strands of 50 Pixels (5v). My question is this: I am using an E682 to control the pixels , taking up almost 5 universes . The E682 supplies power to the pixels. What would be my best option setting the pixels up? if I connected each strand to its own port on the E682 would I need to inject power to each strand. I am using a 350W power supply connected to both sides of the E682? Thanks for any input you all may have!!!

Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

16 Strings, 50 pixels long would add up around 240W plus any line losses, so 1 supply should be fine.

Powering each string from its own output will not need any power injection either. But if you wanted to add more to the controller you would need to buy another controller or re-work your wiring. You would only be using 800 pixels and you can easily double that if you do injection, so add a star to the top, a couple arches,..... whatever you like using the same controller.

What I generally do is feed in one string tie them together at the top and back down the next one. Just jumping the positive and negative at the bottom from the start of the 1st string to the end of the 2nd string generally takes care of it. Now you have 1/2 the wiring from your controller, but you have a little more to do on you string wiring but nothing terrible.


Reply
Posts: 1115
(@11bravo)
Noble Member
Joined: 14 years ago

About my setup, I'm doing 16 strings at 50 pixels each, and tying two strings together at the top, and connecting the plus and minus at the bottom. 18 ga wire should be sufficient from controller to the pixel string, shouldn't it? The longest run shouldn't be more than 3 - 4 feet.


Reply
Posts: 150
(@markl)
Estimable Member
Joined: 19 years ago

My setup is similar to 11Bravo. I had to double up strings into 100 pixels because I have more than 16.

In your case though if you're driving just one 50 pixel string from each output of the E682, I agree with the comments that you don't need to inject additional power.

Mark


Reply
Page 1 / 2
Share: