mega tree pixel que...
 
Notifications
Clear all

mega tree pixel question

7 Posts
4 Users
0 Reactions
2,925 Views
Posts: 3
Topic starter
(@bobmanjr1)
Active Member
Joined: 10 years ago
[#43189]

I am using a e682 and have tested using 3 50 pixel string hooked up end to end hooked up to 1 output on the e682 , my question is how do I setup xlights to know I have done this and do I need to do anything in the e682 controller to make the tree work correctly .
I am doing this to spare outputs on the e682 , so I can run some smaller trees and snowflakes.


6 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

3 strings too make 3 legs of your tree each leg 50 pixels they go up then down then up?? how many legs are you planning on the tree


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago
Screenshot 14

#strings = how many actually strings you have (if you take 3 strings and connect together it is 1 string)
Nodes/String = how many pixels are on string
Strands/ String = how many legs the string makes up

so 3 string of 50 pixels making up 1 string of 150 to cover 3 legs on tree


Reply
Posts: 3
Topic starter
(@bobmanjr1)
Active Member
Joined: 10 years ago

16 total strings of 50 .


Reply
Posts: 3
Topic starter
(@bobmanjr1)
Active Member
Joined: 10 years ago

50 nodes on each string that I have connected end to end . 50 up 50 down then 50 up again .
I don't have to do this im just trying to see if it can be done this way and if so how to setup the software.


Reply
Page 1 / 2
Share: