For 2016 I had a 16 string 800 pixel tree using 12 volt pixels. I also had a star that used 90 pixels. Each port of a 682 ran 50 pixels each and the star ran off an E6804. This year I want to add 100 more pixels to the tree and also use 1 port of the 682 to run the star, eliminating the 6804. I have a couple of choices. Run 100 pixels off each port or, I could use 3 ports to run 100 pixels and the remaining 12 ports to run 50 pixels. That leaves me 1 open port for the 90 pixel star.
12 ports run 50 pixels and 3 ports run 100 pixels and 1 port the star
or
9 ports run 100 pixels and 1 port for the star.
Is there any advantage going either way? I would balance out the number of pixels on each side of the 682 (one side of 682 would have to handle 50 more pixels).
Sent from my SM-T710 using Tapatalk
I would put 450 pixels on each side for the tree, then run a full universe on each output, so the 450 would use 3 outputs on each side (just over 2 1/2) and the star would push one site to 4 outputs
Two of our mega trees use a single 682 each, pushing 100 pixels (12v) out of each of the first 8 ports (50 up, 50 down - folded at the top and in the controller firmware.) The remaining 8 ports were used to push "extra stuff" in the area. Your toppers would fit in this description. With the added pixels you are planning, you could do the same thing with the extra strings and still have plenty of outputs for your topper.
My only concern was using all the ports or run all pixels in groups of 100. I have no plans for using any open ports for anything else. The 682 will be dedicated to the tree and star only.
I have to make a decision on another 16 string tree and 8 snowflakes but I'm pretty sure how I'm going to handle that. There will be 1,184 pixels, 800 for the tree and 384 for the snowflakes. 710.4 watts at 59.2 amps. The 682 can handle it but the power supply would be taxed with no reserve. I'll probably use a 6804 to run the snow flakes which would take the load off the 2 power supplies for the 682.
Sent from my SM-T710 using Tapatalk
You don't have to use all the outputs. 100 pixels per output (300 channels) works great. As stated, we have 8 outputs pushing the megatrees, 2 outputs pushing the tree topper, and 2 others connected to "ground stars". There are 4 outputs just waiting for me to think of something to do with them (aka "empty"). Everything works great.
Also remember, the E682 has two separate power inputs. (outputs 1-8, and 9-16).
