Boyosco Mega Tree Q...
 
Notifications
Clear all

Boyosco Mega Tree Question

63 Posts
25 Users
0 Reactions
33 K Views
jlowe
Posts: 952
(@jlowe)
Noble Member
Joined: 16 years ago

Wolfie, thanks for all the info and sharing your design.

Question: what is the bottom hoop made of? Pvc? How do you keep it secured to the ground and centered once all the strips are mounted?


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

MISR clips on the lower section work as well. Just run the bungee through it, around your lower ring, and connect again.


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

I use bungies on the bottom without the clips. It works just fine, however my trees are only 16x50. For really tall trees it would be a good idea to use clips.

Sent from my Pixel using Tapatalk


Reply
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago
barlav wrote:I also used j hooks for the topper. worked out great. I used hose clamps on the topper where attached at pole because I couldn't tighten it enough for some reason.

I found it works easier to just put a sheet metal screw in the pole to keep it from slipping down. you could also drill a hole all the way thru and put a bolt and nut through the hole.


Reply
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago

I'm with phrog30. Just put bungees thru the holes on the strips. Those strips are really strong. I hook all my strips to the bottom hoop and then pound camping stakes at a slight angle and tighten bungees from the hoop to the stakes to put tension on the hoop and keep it from moving in the wind.


Reply
Page 5 / 13
Share: