Boscoyo Strips ques...
 
Notifications
Clear all

Boscoyo Strips question

6 Posts
6 Users
0 Reactions
3,531 Views
Posts: 98
Topic starter
(@patmitchell)
Estimable Member
Joined: 8 years ago
[#54581]

Does it matter which side of the strip is facing out, smooth or rough? I should have asked this question 15 strips ago...


5 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Not at all.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I have them shiny side out to keep my OCD happy. The strips dont seem to care.


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago
MartinMueller2003 wrote:I have them shiny side out to keep my OCD happy. The strips dont seem to care.

My OCD wants the rough side out to cut down reflections. My strips don't care either.


Reply
Posts: 15
(@bgivney)
Active Member
Joined: 9 years ago

OCD is the only factor there... Just dont go back and forth, jeesh.


Reply
Posts: 1
(@wlll64)
New Member
Joined: 7 years ago
patmitchell wrote:Does it matter which side of the strip is facing out, smooth or rough? I should have asked this question 15 strips ago...

I have the HD strips, and after the first 10 minutes inserting 3 pixels was convinced that I would never finish. Then I noticed that the holes are not exactly cylindrical, they are tapered slightly (perhaps by construction rather than design) than the pixels were WAY easier to insert from the slightly larger side. Inserting from that side may mean that I've gone from not-finishing-before-death to possibly-finishing-in-time-for-this-year.


Reply
Share: