So this year's show is running smoothly. Planning for next year has begun. I am adding 2 more mega trees. I already purchased the lights. It is going to be red, green and white. I have 4 red strings for each tree (doubled over to make 8) 4 green (same) and 8 cool white (doubled over to make 16) all x2 to make 2 trees. I am planning on doing 2-12ft trees, 6ft diameter base, and 16 strings, doubled over to make it 32 strands coming down. That puts each strand about 6" apart at the base. Does this sound like a good tree or no? Anyone have pics of something similar? Should I go wider at the base? Thanks
Sent from my SAMSUNG-SM-G870A using Tapatalk
your base diameter sounds ok, you could go wider, any way to test out different diameters before you go for it so that way you are sure you are happ with it? Are you sure you are going with cool white? In my opinion they aren't as attractive as warm white, but if you already have a lot of cool white in your display then stay consistent.
So 16 strands on a 12 foot tree (I am presuming 4 inch spacing, 100 light strings). It sounds good. Just remember that as you increase diameter size of the base, you are decreasing the light density, see area of a cone calculator. https://www.google.com/search?q=calculate+the+area+of+a+cone
Based on the data provided and assuming 100 light strings, your light density is OK I think. Again, any chance of a test before next year?
roughly (area of your tree) 145'X144inches per sq ft area with 1600 lights is like 1 light per 13 square inches, whereas in the photo below it is 1 light per 9 square inches, to my eye, it is very dense (my photo). I like it that way.
if you increased diameter to 7 feet, then your area increases to 176 feet/25344 sq inches and your light density decreases to ~1 light per 16 inches.
It all depends on what appeals to YOU!
Is this static or on a controller?
20 foot tree with 80 strings of 100 lights all incan
12 foot diameter (6 foot radius) = ~507 square feet = ~73000 sq inches

