Notifications
Clear all

Word Clock

7 Posts
4 Users
0 Reactions
3,945 Views
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago
[#48104]

I would really like to build a Word Clock. Of all the projects online this seems to be the best
https://www.jeremyblum.com/2016/02/03/wordclock/

I am way over my head when it comes any coding that might be needed - but feel his files would get me going. The built will be no problem for me.
My question is could I use Ron's Pi Hat adapter https://ronsholidaylights.com/raspberry-pi-matrix-adapter/ instead of this one https://www.adafruit.com/product/2345 and still have it work?

The other item would how to at the RTC https://www.adafruit.com/product/3296 to the Pi?

Suggestions?


6 Replies
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

So.... word clocks are a hobby of mine.

If you are interested, and clever, I have PCBs of the Clock3jr available.
Here is the info for it...
https://www.kickstarter.com/projects/252714519/clockthree-jr
http://www.instructables.com/id/How-to-build-C3Jr-a-sophisticated-word-clock/
https://www.seeedstudio.com/Clock-THREEjr-%28with-black-faceplate%29-p-1387.html

Also.... I have my version of Ri's pi adapter available as a bare PCB for only $1.50.

That RTC you note from adafruit is available at aliespress for about $1. Its very common.

PM me if you would like more info


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

Thanks but I am interested in using P10 panels - but your clocks are beautiful.


Reply
Posts: 843
(@captainmurdoch)
Prominent Member
Joined: 14 years ago

As long as your P10 panels use the HUB75 interface then you should be able to use Ron's adapter. You may have to change the PIN numbers in the Python code because the adafruit hat uses a different set of pins I believe. The library we use for FPP supports the adafruit pinout as well as the better pinout that is on Ron's hat and other hats available from others.

You do need to make sure that the panel you are getting does not use the "E" address line. I don't think that will be an issue on the 32x32 panels. As far as I know, none of the hats we use for driving panels with FPP support the E address line.


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

Thanks Captain

I was planning on using the same (extra) 32X16 panels I used on my matrix - which were purchased form https://www.crockettfantasyoflights.com/product/p10-matrix-panels/ .

I am assuming they use the HUB75 - from what my connectors look like. Where will I find the E address line - in the code?


Reply
Page 1 / 2
Share: