Projector Screen Ma...
 
Notifications
Clear all

Projector Screen Material

5 Posts
4 Users
0 Reactions
3,677 Views
Posts: 26
Topic starter
(@tnf250)
Eminent Member
Joined: 12 years ago
[#54550]

I will be adding a virtual matrix using a projector for this season. I've been looking at some of the screen material available on amazon, PVC and EPPE Polymer but after reading the reviews it appears this type of material is affected by temperature. I would mount this to a home build fame so that it is taught but in the off-season it will be stored in a place that would fluctuate temperatures greatly most likely producing wrinkles.

The space I intend to use is approximately 12' x 8'. I would like to utilize as much of that space as possible without distorting the images or going beyond the projector capabilities. It's a red brick wall, so whatever I use needs to be non-transparent. It also needs to hang from that wall so that it is off the ground about 4'.

I was wondering what others are using or if anyone had any suggestions.


4 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

If you design it to be removed from the frame, you can roll it up on a tube.
Other than the obvious part of getting the whole thing down to a manageable size, it also allows for keeping everything clean and without wrinkles.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Although expensive, rear projection screen material is a heavy, gray stretchy rubber material that works great with frames.


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago
TNF250 wrote:I will be adding a virtual matrix using a projector for this season. I've been looking at some of the screen material available on amazon, PVC and EPPE Polymer but after reading the reviews it appears this type of material is affected by temperature. I would mount this to a home build fame so that it is taught but in the off-season it will be stored in a place that would fluctuate temperatures greatly most likely producing wrinkles.

The space I intend to use is approximately 12' x 8'. I would like to utilize as much of that space as possible without distorting the images or going beyond the projector capabilities. It's a red brick wall, so whatever I use needs to be non-transparent. It also needs to hang from that wall so that it is off the ground about 4'.

I was wondering what others are using or if anyone had any suggestions.

Something like THIS? It is a bit smaller than you specified, but close.


Reply
Posts: 26
Topic starter
(@tnf250)
Eminent Member
Joined: 12 years ago

Thanks for the suggestions. I went with a 3 layered PVC version.

Once mounted to the frame I think I will leave it and see how it works out when storing this year.


Reply
Share: