Pixel Matrix Spacin...
 
Notifications
Clear all

Pixel Matrix Spacing Templetes

5 Posts
3 Users
0 Reactions
2,907 Views
HydroWVU
Posts: 48
Topic starter
(@hydrowvu)
Trusted Member
Joined: 13 years ago
[#35322]

I am planning my pixel matrix for next year and I needed to visualize various spacing between 8mm Pixel bulbs. So I created a spreadsheet with 5 different spacing options.

1 Inch between Pixels
1.25 Inches between Pixels
1.5 Inches between Pixels
1.75 Inches between Pixels
2 Inches between Pixels

The spreadsheet is attached. Just print it out and you can get a pretty good small visual representation of various pixel spacings.

I had my wife hold them up while I looked at it from the street. This ultimately let me decide on the minimum amount of pixels I
could buy and my matrix still look good.

I hope this will help someone else.

John


4 Replies
Posts: 686
(@traneman)
Prominent Member
Joined: 16 years ago

so what spacing did you end up with ?


Reply
HydroWVU
Posts: 48
Topic starter
(@hydrowvu)
Trusted Member
Joined: 13 years ago

I decided to use 1.5 inch, and 48" x 48" matrix. I was concerned about brightness of 1 inch spacing. I purchased a test RBG strip last year it was 12v 2811. But I didn't have a chance to get it hooked up and tested until this week (I was way behind getting everything ready for this year). WOW was it bright. I attached it to my wall in the basement and that one strip will light my entire basement. My house is only about 16' to 20' from the road, and probably only 100' from my neighbor across the street. I was worried that 1inch spacing would be way to bright.

John


Reply
Posts: 184
(@micromutt)
Estimable Member
Joined: 12 years ago
HydroWVU wrote:I was worried that 1inch spacing would be way to bright.
John

Maybe it's too much work but can't you control the brightness with your sequencing software?


Reply
HydroWVU
Posts: 48
Topic starter
(@hydrowvu)
Trusted Member
Joined: 13 years ago

I think I can, at least I can control the brightness from the testing I have been doing with nutcracker. I haven't figured out sequence the pixels yet. I have only played with them in test mode.


Reply
Share: