Hi,
I want to build a double sided matrix using 36 P10 panels per side (total 72 panels) in a 6 x 6 arrangement for outside use, can this be done, is it advisable and what would be the best setup/configuration?
I have already contacted DIYLEDexpress and emailed Todd for some info but I want to know what the forum thinks about this project. I have read some of the threads concerning multiple P10 setup and gleaned some good starting points any ideas and suggestions is appreciated.
Thanks in advance,
BillW
the issue with the panel count is your looking at 2 controllers no matter which way you do it... the pi has a 36 panel max the bbb is 64 panel max
the pi refreshes at 20mhz the bbb at 1 mhz... that is the biggest difference between them is the refresh rate. since you want 2 36 panel signs the pi i would say is a better option. 2 of them synced using the fpp. i would use boscoyo studios p10 stuff to hold them together... use 1x2's around the outside of them then screw the 1x2 into a 2x10 or 2x12 frame... cut grooves 1 inch in on both sides of the 2x10's to hold plexiglas, input your power on one side. Yea completely doable... my matrix is 6x6 (36 panels) and i use a 2x6 frame there is plenty of room.
This is a back look at the panel
here you can see the front with the groove cut in for the plexiglass
kinda dark but you can see how much room the back of the panels have so a 2x10 would probably be enough though 2x12 may be better.
Thanks for the I input. I have been talking with Todd at DIY LedExpress, he is recommending the BBB, I'll ask him about the pi since it has a faster refresh rate this may be better. The pictures help a lot, I have reviewed Ron Howard's YouTube videos, do you have any I could watch?
Thanks again.
there is my panel in action if thats what your talking about



