Pin layout
 
Notifications
Clear all

Pin layout

12 Posts
4 Users
0 Reactions
5,946 Views
Posts: 104
Topic starter
(@trioxide)
Estimable Member
Joined: 11 years ago
[#42345]

Just purchased a generic Serial to RJ45 adapter and need to know what the pin layout is so I can wire the adapter properly to connect to the CTB16PC I just purchased. Looking to wire it up the same as the SC485-RJ45 Serial Adapter you can find on the LOR website.

Thanks


11 Replies
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

The adapter plugs into a serial port on your PC (or USB to Serial) and You just use a standard ethernet patch cable to run from the adapter to the controller.

Attached is the pin out for the DB9 to RJ45


Reply
Posts: 104
Topic starter
(@trioxide)
Estimable Member
Joined: 11 years ago

Yes I know that but the adapter I bought does not have the pins connected between the serial and ethernet side. I need to know what pin on the serial side goes to what pin on the ethernet side so it is wired properly. I could not find anything online for the SC485 but there were many other adapters with different wiring so I do not know what I need.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

I figured that out after I posted, I added the PDF that is for a standard Serial to RJ45 pinout.


Reply
Posts: 104
Topic starter
(@trioxide)
Estimable Member
Joined: 11 years ago

Darn. I just broke a connector trying to pull it out to redo the layout. Will have to buy another one and try the layout you sent. The adapter is only $2, compared to $30 on LOR, so no problem.


Reply
Page 1 / 3
Share: