I was looking at the Startech document. The termination chart shows which colors are connected to the RJ45.
Where did you get the information as to which pins on the DB9 should be connected to which pins on the RJ45?
That is all from the started pdf. I did not add anything
Trioxide wrote:Darn. I just broke a connector trying to pull it out to redo the layout. Will have to buy another one and try the layout you sent. The adapter is only $2, compared to $30 on LOR, so no problem.
Whoa! Got a link so I can get a dozen? =D
Drew
Ruppro wrote:Attached is the pin out for the DB9 to RJ45
Okay. Got another generic adapter and did the pin layout as displayed in the pdf you provided. Ran LOR Hardware and trying to locate my CTB16PC but it can not find it. Tried the Auto Configure and Manual Select but can't find it. Any help would be appreciated.
Trioxide wrote:Okay. Got another generic adapter and did the pin layout as displayed in the pdf you provided. Ran LOR Hardware and trying to locate my CTB16PC but it can not find it. Tried the Auto Configure and Manual Select but can't find it. Any help would be appreciated.
Sorry about the mis-information, I was not thinking clearly that it is not going to be a straight normal pinout. I can't believe no one has hacked one to get the pinout. And I can't believe (well I guess I can) that not only is the adapter from LOR $30, the shipping would be another $17! (UPS Ground) After searching for any reference to the pinout all I could find was this one reference in the Renard Data Cable Wiki
DMX(RENARD) to DMX(LOR) using RJ45 (CAT5) Connectors
RJ45 connector pin 5 (Data+) to RJ45-pin 4
RJ45 connector pin 4 (Data-) to RJ45-pin 5
RJ45 connector pins 1&2 (GND) to RJ45-pin 6
This tells us that it appears that the LOR controllers look for Data+ on pin 4, Data- on Pin 5 and GND on pin 6 (of the RJ45)
Another section of the same document explains how to build the DE9 to RJ45 for the Renard connector,
Insert the pin on the wire connecting the soldered together wires for pin 1-blue, 2-orange into DE9 connector pin 5.
Insert the pin on the red wire (RJ45, pin 4) into DE9 connector pin 1.
Insert the pin on the green wire (RJ45, pin 5) into DE9 connector pin 2.
if we apply that w/ the the above modifications for LOR the following should be the pinout
Insert the pin on the yellow wire (RJ45, pin 6) into DE9 connector pin 5.
Insert the pin on the red wire (RJ45, pin 4) into DE9 connector pin 2.
Insert the pin on the green wire (RJ45, pin 5) into DE9 connector pin 1.
This is all just guess work on my part, if someone had a LOR dongle it would be very easy to ohm it out to get the proper pinout, like I said, I can't believe no one has.
Again, I am sorry for my first bonehead reply.
